| 10:43 | topi`> | jnettlet: I have some boards where the SPL is being loaded, but it stops when trying to boot from MMC1 |
| 10:43 | topi`> | spl: mmc boot mode: raw |
| 10:44 | topi`> | I have no recollection what is a "raw" mmc boot mode. |
| 10:45 | topi`> | it seems I cannot force it to boot from a SDcard. with jumpers or without... |
| 10:45 | topi`> | maybe should try to force EMMC into reset? there was a pin |
| 10:51 | topi`> | spl: could not find mmc device. error: -19 |
| 10:52 | topi`> | is there somewhere a table for these error codes? |
| 20:05 | jnettlet> | topi`: the reset on eMMC only works if the eMMC firmware is programmed to support it. It is a built in security measure that it defaults to off |
| 20:06 | jnettlet> | topi`: the errors are documented in the kernel. But are you sure the device isn't falling back to USB recovery mode there? |